Ne555 โมดูลเครื่องกําเนิดไฟฟ้าความถี่ชีพจร 10Khz -200Khz สําหรับ Arduino Diy

NE555-Red：

1, Size: 3.1CM * 2.2CM 1, the main chip: NE555;

2, Input voltage: 5V-15VDC. 5V power supply, the output current can 15MA around; 12V power supply, the output current can 35MA around;

3, the input current: 100MA

4, the output amplitude: 4.2V V-PP to 11.4V V-PP. (Different depending on the input voltage, the output amplitude will be different)

5, the maximum output current: 15MA (5V power supply, V-PP greater than 50%), 35MA (12V power supply, V-PP greater than 50%)

The scope of this module:

1 is used as a square wave signal generator generates a square wave signal used for experimental development.

2 to drive a stepper motor for generating a square wave drive signal.

3 adjustable pulse generated for use by MCU.

4 adjustable pulse generation, control circuitry associated.

Advantages: 1, the output with LED indication, there is no output straightforward (low LED volume, high LED off frequency is relatively low, the LED flashes);

2, the output level selectable frequency range, the output frequency is more continuously adjustable; LF file: 1Hz ~ 50Hz IF file: 50Hz ~ 1kHz High-frequency file: 1KHz ~ 10kHz HF file: 10kHz ~ 200kHz

3, the output duty cycle can fine-tune, duty cycle and frequency is not separately adjustable, adjusting the duty cycle will change the frequency

4, the output frequency is adjustable; Period T = 0.7 (RA +2 RB) C RA, RB is 0-10K adjustable; Low profile when C = 0.001UF; IF stalls C = 0.1UF; High-frequency file C = 1UF; HF stalls C = 100UF, so the frequency of the waveform buyers can own calculations

NE555-Blue：

1. Onboard NE555 IC.

2. Single channel signal output, the output duty cycle about 50% square wave.

3. Plate load resistor, adjust the resistance to control the output frequency.

4. Onboard power indicator. 5. Working voltage: 5V~12V.